What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 29.06.2025 02:53
(Dc diagram shown, AC is similar).
These are simplified answers to the original question, and does not change anything I wrote above.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Your daily horoscope: June 17, 2025 - The Globe and Mail
So, the voltage could go up to 500 volts, and the fuse will not open up.
This one hit behind the barn.
This device then solves the entire problem.
When the mind leaves the body - scientists investigate the incredible phenomenon of OBEs - Earth.com
This is 'the assistant's answer'
Edit 2024–10.
a photo is worth a thousand words.
All four iPhone 17 models just tipped for ‘metalens’ upgrade - Tom's Guide
These devices are installed between the “hot” and “neutral” and protective ground.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
In schematic diagrams this is the symbol for a fuse:
Why are 38% of IIT graduates unplaced in 2024?
[old diagram got deleted by accident]
He then describes Rainy Season and Lightning.
First Sentence:
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The other is “what does a “fuse” do?”
[image of Common-mode choke]
5 foods to add to your diet to prevent magnesium deficiency - Times of India
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
but I think this circuit , shows a few more pieces.
But… the neutral is now “floating” because of the 1 ohm resistance.
Astronomers discover new evidence of intermediate-mass black holes - Phys.org
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is the picture of an electronic coil of wire wound around a core of magnetic material.
but this device (an Inductor) … impedes the rapid changes in the current.
Is modular building a fix for NY's housing crisis? State officials hope so. - Gothamist
nine
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There are two important concepts here.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
A circuit breaker is similar, but is resettable.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Light Squeezed Out of Darkness in Surprising Quantum Simulation - ScienceAlert
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
the problem then depends on "how fast does the fuse operate?".
I post the exact comment here.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
eight
what exactly is a ‘surge’ protector?
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–10[John johnson John Johnson ]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–14 [Omar Gharbi Omar Gharbi ]
The MOV will conduct when the voltage exceeds 50% of line voltage.
But it can get overloaded, and no longer works.
A fuse is a non-resetable over current circuit protector.
There are three different concepts here that are getting confused.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
so, what happens?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
It seems Mohan does not understand the difference between a comment and an Answer.
What is lightning?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
The third is lightning and “how it gets conducted into a home.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It also is a device that limits the change in current flow.
What does a fuse do?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At one ohm, the resistor has a maximum of 1 watt power.
Now when you have a certain ac resistance, then a current flows in a loop.
Because the load is inductive, the current lags the voltage.(by a bit).
For this case there are devices called Metal oxide varistors (MOV).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
He then describes the function of a fuse.
Barnstars:
This is where this question deviates from being a 'generic' question, and becomes more specific.
He then asserts :
The bolt then partially travels down the line to your home.
An AC voltage/ current source, and an ac inductive load.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is where the MOV conducts again, and dissipated the energy.
Here is a simplified AC power diagram.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Upvotes:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One
At least they know the answer if they wanted it.